Requires TQM Wheel End Training Part 1
Has Prerequisite
TQM Training Part 2 – Guardian® HP Quiz
Time limit: 0
Quiz Summary
0 of 12 Questions completed
Questions:
Information
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Quiz complete. Results are being recorded.
Results
0 of 12 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 12
1. Question
How many levels of inspection are involved in TMC RP 631B?
CorrectIncorrect -
Question 2 of 12
2. Question
What are the three main lubricants being used today in wheel ends?
CorrectIncorrect -
Question 3 of 12
3. Question
If High Temperatures are noticed during inspection, what are the usual causes?
CorrectIncorrect -
Question 4 of 12
4. Question
A LEVEL II inspection should be done:
CorrectIncorrect -
Question 5 of 12
5. Question
A LEVEL III inspection is:
CorrectIncorrect -
Question 6 of 12
6. Question
Bearing Adjustment is checked by:
CorrectIncorrect -
Question 7 of 12
7. Question
STEMCO Guardian HP Seals are installed:
CorrectIncorrect -
Question 8 of 12
8. Question
Silicone should be installed around the ID and OD of the Guardian HP Seal
CorrectIncorrect -
Question 9 of 12
9. Question
STEMCO ProTorq and ZipTorq spindle nuts are
CorrectIncorrect -
Question 10 of 12
10. Question
Spindle Shoulders and Hub Bores should be cleaned to remove contamination, rust, and burrs with:
CorrectIncorrect -
Question 11 of 12
11. Question
If Semi-Fluid grease is used in a wheel end, the proper fill level is:
CorrectIncorrect -
Question 12 of 12
12. Question
Hubcap bolts should be torqued to:
CorrectIncorrect
